ABSTRACT
ABSTRACT@#Good denture hygiene is crucial for the prevention of various periodontal diseases, dental caries and dental stomatitis, which can give rise to a negative impact on the general health of denture users. A comparison exercise was conducted, to determine the effectiveness of information on denture care, provided by different groups of dental personnel. A self-administered and structured questionnaire was distributed to patients who attended Hospital USM’s dental clinics, from 2014 to 2019 based on the attendance register of the clinic. The denture hygiene status of 100 participants was assessed during the interview session. The results derived through the questionnaire revealed that 100% of the respondents, who received both verbal and written instructions, practiced good dental hygiene. It was observed that the most effective instructions received by the respondents were delivered by the dental specialists. Respondents, who clean their dentures with denture cleaning tablets, soap, or denture cleaning paste, were observed to possess better denture hygiene than those who do not. Also, respondents who visit their dentists once every six months for routine dental examinations boasted a higher percentage of good denture hygiene (81.8%). A positive association was perceived, between knowledge and the status of denture hygiene.
ABSTRACT
Light intensity output is one of the determinants for adequate curing of visible light-cured materials. The aim of this survey was to evaluate the light intensity outputs (LIOs) of light curing units (LCUs) in dental clinics of Hospital Universiti Sains Malaysia (HUSM) and School of Dental Sciences, Universiti Sains Malaysia (USM). The respective LIOs of all functioning Quartz Tungsten Halogen (QTH) and Light Emitting Diode (LED) LCUs were tested using two light radiometers. For cordless LED LCUs, the testing procedure was done in situ and after being fully charged. Statistical analysis using Kruskal Wallis and Wilcoxon signed ranks tests were performed to compare the LIOs between groups and between the LIOs of in situ and post-charged cordless LED LCUs, respectively. The level of significance was set at 0.05 (p<0.05). The results revealed that 72.72%, 42.47% and 92% of QTH, cabled LED and cordless LED LCUs exhibited acceptable LIOs, respectively. Data analysis using Kruskal Wallis test showed a statistically significant difference between groups (p<0.05). The intergroup comparisons using multiple Mann Whitney test with Bonferroni correction revealed a significant difference between the LIOs of cordless LED and both QTH and cabled LED (p<0.017). The difference between the LIOs of in situ and post charged cordless LED LCUs was also significant (p<0.05). In conclusion, both QTH and cordless LED LCUs performed better in term of LIOs than cabled LED LCUs. Periodic testing of LCUs is essential to ensure optimal performance.
ABSTRACT
Replacing a single missing anterior tooth can be a challenge. Many factors need to be considered when choosing the appropriate treatment. Several treatment options are well established. This case report is to present the use of a cast cobalt chrome partial denture with custom made porcelain tooth to improve aesthetic. The overall shade of the artificial tooth were nicely matched with the adjacent teeth and definite enamel translucency could be achieved which would not be possible with acrylic or even with readymade porcelain tooth.
ABSTRACT
The in vitro cytotoxic potential of locally produced dental porcelain was evaluated in this study. The cellular response of human osteoblast and fibroblast cell lines were assessed using MTT assay by incubating with the fluid extract of dental porcelain powder and dental porcelain discs (direct test). Aging process was carried out by submerging the discs into 3% bovine serum albumin (BSA) solution. Tests on extracts showed that dental porcelain was significantly different from the control at a concentration of 250 mg/ml. Direct test showed that dental porcelain after aging was not significantly different from the control with a mean (SD) of 89.2 (13.4)%, whereas, it was significantly different from the control before conditioning of BSA with a mean (SD) of 88.5 (12.1)%. However, the dental porcelain caused mild suppression of succinate dehydrogenase activity (<25%), which is considered to be accepted clinically and hence can be ranked as being non-cytotoxic.
ABSTRACT
Some restorative materials are susceptible to erosion but whether it also causes microleakage is still questionable. The aim of this study was to assess the microleakage of few restorative materials after immersion in acidic solution. Standardized ‘U’ shaped cavity of 4mm diameter and 2mm depth were prepared on buccal or lingual surface of 52 human premolar and molar teeth. The teeth were divided into 4 groups which contains 13 samples and 3 controls for each and were restored either with Filtek Z250 (Group 1), Fuji IX (Group 2), Fuji II LC (Group 3), or Silverfill amalgam (Group 4). All surfaces were painted with nail varnish leaving only 2mm of tooth structure surrounding the restoration before the study samples were immersed in acidic solution, lemon juice (pH 2.74) and control samples in deionised distilled water for 24 hours. Surface photos for erosion were taken before immersion in methylene blue for 7 days. After sectioning, the assessment of dye penetration was done using Leica Imaging System DMLM (Germany). Photos showed that Fuji IX demonstrated severe erosion but no obvious changes were seen on other materials. Kruskal-Wallis test indicated that microleakage between all four groups were statistically significant. The most significant difference was between Filtek Z250 and Fuji IX (p<0.05). Fuji IX was the most affected by the erosion process and its degree of microleakage was the most among all the materials tested.
ABSTRACT
Tooth wear is the loss of tooth tissue and structures not due to caries. It can occur in various forms either attrition, abrasion, erosion, noncaries cervical lesion (NCCL) or a combination of two or more forms. The objective of this study was to determine the patterns and associated aetiologies of tooth wear among adults in Kelantan, Malaysia. This crosssectional study involved 81 adults with tooth wear which was visually assessed using the Smith and Knight Tooth Wear Index (TWI). A questionnaire was used to seek putative aetiologies of the wear. Data were analyzed and the results were expressed as frequencies and percentages. Six thousand three hundred and eighty four tooth surfaces were examined in 1596 teeth. 17.4% surfaces had tooth wear; 80% scored 1, 18% scored 2 and 2% scored 3. Among the 81 cases of tooth wear, 29 (35.8%) had abrasion; 25 (30.9%) had attrition; 1(1.2%) had erosion while 26 (32.1%) had the combined type. Among those with abrasion, majority had the habit of eating freshwater clams (Corbicula fluminea) as local delicacy where most of the times people use their teeth to pry open the clam shells. Erosion was related to the pooling of carbonated drinks or beverages in the mouth before swallowing. In conclusion, most adults experienced abrasion and the most common possible associated aetiology is the way of eating clams.
ABSTRACT
Endodontically treated teeth are generally weaker than sound teeth. The study objective was to compare the fracture resistance of endodontically treated teeth restored with different restorative techniques. Fifty extracted human maxillary central incisors of similar size were divided into five groups of 10 teeth. Group 1 was left intact as the control group. Other groups (Groups 2, 3, 4 and 5) were all endodontically treated followed by restorations using different restorative techniques; light cured composite resin (CR), CR and crown, post and CR, and post-CR core and crown respectively. The specimens were loaded in a universal testing machine with a static force at a crosshead speed of 0.5mm/min at 135° to the long axis of the root until failure. The means and the standard deviations of the maximum load at failure for groups 1, 2, 3, 4 and 5 were 1259.11N (379.12N), 578.63N (196.70N), 667.13N (298.72N), 1247.65N (294.48N) and 623.60N (193.75N) respectively. The results of one-way ANOVA showed statistically significant differences existed among the groups tested (p<0.001). Independent t-tests showed that the fracture resistance of specimens restored with either light cured composite resin or crown was statistically lower than the natural tooth (p=0.001 and p=0.003). Restoring endodontically treated with post significantly increased its fracture resistance to the level of sound tooth (p=0.002). Within the limitations of this study, endodontically treated teeth restored with post exhibited similar strength with sound natural teeth and restoration with either light cured composite resin or crown had lower fracture resistance than natural teeth.
ABSTRACT
Composite resins Amaris is claimed to have hydrophobic effect which minimizes the staining intake. This study is to investigate the colour stability of Amaris compared to Filtek Z250 in coffee solution. Sixty discs of composite resins Filtek Z250 (3M ESPE) and Amaris (Voco) with diameter of 5mm and depth of 2mm were fabricated by packing in a drinking straw and sectioned with hard tissue cutter (Exakt, Japan). The surfaces of the specimens were polished with Sof-Lex disc before each group of the samples is immersed in coffee solution. They were kept in the solution for 4 days at 370C and assessed at the period of 2 hours, 1 day, 2 days, 3 days, and 4 days. The staining was assessed visually and recorded using Lobene (1968) Stain Index and score was given accordingly. The colour changes of both groups were not statistically significant (p<0.05) for period of 2 hours, 1day, 2 days, 3 days and 4 days All groups showed the score values increased gradually with time. Both composite resins have similar colour stability in coffee solutions.